SELLING Custom shrouds for Bat actions

[Alex Wheeler]

I have these shrouds made to my specs. They are over sized so they have to be fit to the bolt. They also incorporate a unique node design that allows the spring to clip over the end, keeping it from touching the firing pin. I have been fitting shrouds to actions for years now and it makes a real difference on target. It allows you to achieve a bind free situation without slop. A loose shroud fit requires more clearance in the whole system to work well. I have shared the nose design with Bat and most likely you will see it in the future from the factory. These have a full length id diameter which I recommend leaving that way. Do not drill them out. Keep in mind, these need fitting by a good smith. Thats the whole point. They are not drop in. $100 shipped.

 

[ohiofarmer]

Alex, those look great. Are they stainless or aluminum? (Or even chrome moly in the white?)

 

[Alex Wheeler]

SS

 

[Jud96]

The way a shroud should be made to improve ignition

 

[ridgeway]

Alex...what type of stainless? That's a good idea centering the spring.

 

[Ledd Slinger]

Do these work on a HR Lapua action and/or does an HR need it?

 

[LVLAaron]

What portions need to be fitted?

 

[Alex Wheeler]

Do these work on a HR Lapua action and/or does an HR need it?

Yes and no. They will work but these are a smaller diam. Meant for the B, DS, S, ext.

 

[Alex Wheeler]

What portions need to be fitted?

That will depend on your bolt, firing pin and cocking piece. Those parts are not all the same. Everything needs to be fitted as needed. Every action is an individual.

 

[Kyle Schultz]

That will depend on your bolt, firing pin and cocking piece. Those parts are not all the same. Everything needs to be fitted as needed. Every action is an individual

If I send you the bolt and guts, can you do the fitting? Left-hand parts. Thanks.

 

[Sandbagger1]

If I send you the bolt and guts, can you do the fitting? Left-hand parts. Thanks.

Diddo but right handed?

 

[WSnyder]

$100 shipped.

Best form of contact to purchase? PM here, email, text or call from website contact info?

 

[Alex Wheeler]

Guys, I only fit these on my builds and barreled actions, I just dont have the time to do more than that. Sometimes I will do a full action, but that depends on my work load. Im really trying to get my lead times down for my customers so I have to limit what I take. I am only selling off some surplus because I have some new ones coming. I do not normally offer this stuff, I keep it in house. So when this batch is gone they are gone.

 

[Alex Wheeler]

Best form of contact to purchase? PM here, email, text or call from website contact info?

Sure, any of the above works. Maybe for these, pm me so I can keep them all in one place.

 

[R.Morehouse]

Yes and no. They will work but these are a smaller diam. Meant for the B, DS, S, ext.

Will this work on a 3L?.......If so, I will take one.

Regards
Rick

 

[Alex Wheeler]

Will this work on a 3L.....If so, I will take one.

Regards
Rick

3Ls are different.

 

[Alex Wheeler]

Alex...what type of stainless? That's a good idea centering the spring.

Thanks. Not that the springs rub much at all on Bats, but it is a small improvement. I have done this over the years just by turning the nose down a little. You can do it on any shroud. Im not sure on the type of steel off the top of my head. Id have to check. Its not critical.

 

[Alex Wheeler]

These are no longer available.