Contact details for 6BR-DX owners

[AckleyImproved]

Hi

I am after contact details for someone like David Stripling or Doug Paschall about the 6BR-DX.

I am wanting a FL die for this caliber, and from reading the gun of the week story, I see one has been made using a undersize reamer.

I would like a die cut with this undersize reamer, so I would have a FL die. Reaming the comp. seater and neck die is ok for the others.

I would like a email contact if I could, as I am located in Australia. I will buy the chambering reamer!

I like the extra boiler room of this case, but also the longer neck. I plan on using the 87Vmax out of it, and if I can get the 3200-3300fps mark it will be a very good long range varminter.

Cheers
AI

 

[Forum Boss]

AI,

I just sent you an email with contact info for David and Doug. If you don't get it, let me know.

It was sent to the noogies300 email you have on file.

 

[AckleyImproved]

Thanks for that. I have sent them both a email.

I am getting a Lawton 7500 1.4" dual port action, a 26" Lawton 10 twist barrel, and usign a BRX stock. Should be a nice little varmint whacker!

Cheers
AI

 

[tmbryant]

I checked reamer prints between the 6 BRDX and the 6 Dasher. You should be able to use a Redding 6 Dasher type S full length die and have it shortened to fit the BRDX. For a seater, you can either have a 6 BR Wilson seater die reamed with the BRDX or have a Redding competition seater in 6 BR reamed with the BRDX reamer. The 6 Dasher Type S die is available from Redding as a custom die and is most generally in stock.