i got a little bored and wanted to use my new table saw that I got for Christmas so I decided to come up with some elaborate and unnecessary contraption for drying brass. I just thought I would share the final product.
I built a box that is about 3.75” tall not counting the rubber feet. On the bottom I cut two 3” holes with my hole saw and beveled them for the heck of it. I installed some fans in the box to assist the drying.
I laminated some pegboard to the top, drilled out the holes in the pegboard, flush trimmed it and then beveled the edge. A very sloppy stain job later and it was done.
I drove some finishing nails to rest the brass on (which I know is not a new concept).
I built a box that is about 3.75” tall not counting the rubber feet. On the bottom I cut two 3” holes with my hole saw and beveled them for the heck of it. I installed some fans in the box to assist the drying.
I laminated some pegboard to the top, drilled out the holes in the pegboard, flush trimmed it and then beveled the edge. A very sloppy stain job later and it was done.
I drove some finishing nails to rest the brass on (which I know is not a new concept).
