You need to start a new name thread
It will be fun
It will be fun
Can't fit my fingers in there. All kidding aside, no.
I have checked others. No rings.Do you have another rifle to check? I bet they all have that ring.
I have checked others. No rings.
^^^^^^^^this^^^^^^^^^Set that endoscope out about 100 yards and shoot it with the barrel in question. Problem solved and no more ring. After that, save up for a Hawkeye and look at the inside with your own eye!
Never said I was looking for a problem. I said I was trying to figure out what they were.^^^^^^^^this^^^^^^^^^
The barrel shoots, targets prove it.
Stop looking for a problem where one dosen't exist.
Or split that puppy down the middle and take a real look at it.
I personally will never scope one of my barrels. As long as they shoot as I want them to, when the day come they dont....
See ya by, time for a new one.
I'm betting Frank hit it, drill Mark's that the bore reamer never completely removed.
Wouldn't drill marks only show on the top of the lands? The grooves would be cut away during rifling, removing any trace of drill marks from that area, no?
Set that endoscope out about 100 yards and shoot it with the barrel in question. Problem solved and no more ring. After that, save up for a Hawkeye and look at the inside with your own eye!
Well if the ring was evident in a reamed hole it would never be rifled in our shop plain an simple it's a optical illusion what he is seeing.If theres a ring left by machining whether drill or reamer and not taken out before pulling the button it will still be there after. I'm sure Frank has seen it or he wouldn't have mentioned it and I'm sure Stan has too.
On cut rifled barrel the groove is cut an then lapped to get rid of reamer marks an lapped to final dimensions.I'm not an expert on making barrels but I beieve the procedure is as follows.
1. The barrel blank is drilled.
2. The drilled hole is reamed.
3. If it's cut rifling a cutting tool is pulled thru the bore while it's rotated. I assume it cuts both land and grooves. This cutting would remove any reamer marks.
4. Next the barrel is lapped with an abrasive by pulling the lapping compound back and forth in the bore. No rotation. All scratches straight down thee barrel.
As far as my screen name, no one liked it so I had it changed. Hope it's better.
Maybe the adults here can move on and become just that....adults. stop judging people by a name and rather by their character, especially when you know nothing about them.It appears to me you prefer to engage in passive-aggressive behavior when you encounter unexpected difficulties or perceived disrespect.
There are sharks in this pond. Best to not do any bleeding.
Maybe the adults here can move on and become just that....adults. stop judging people by a name and rather by their character, especially when you know nothing about them.