annealer

[Buck 89]

What are the pros and cons on a Gairuad Annealer?

 

[Heavies]

Pros:
Fast and easy to run a whole bulk of brass. No need to feed the unit one piece at a time.

Cons:
When changing to different lengths of brass, say from 6mmbr to .308 to .30-06, the length difference makes it a little difficult. To switch for differing lengths requires you to unbolt the shell feeder device (the blue colored thing in the center) and add/remove the provided washers to fit the brass.
.30-06 brass sometimes tends to tip off the case spinner part. One needs to keep an eye on it to make sure all the cases get annealed. I usually keep an eye on it while it is working with a small t-handle allen so that I can scoop up the ones that fall off and put them back onto the feeder.


Once you have it setup no problems and you can do a ton of cases in a short time.

 

[Buck 89]

Thanks for the info.

 

[jonbearman]

I have a ballistics edge I believe its called,anyways it has the one size fits all wheel and adjustments are easy(twin torch) ,it doesnt spin the case for the exact factory look. It does however do a fine job of annealing and I can hardly keep up with it. Would I buy that one again,absolutely.