Almost ran out of elevation?

[memilanuk]

If you get a *good* set, from NSS, I'd say it's very likely. Another set of factory nut / lug... might, might not. It's a crapshoot, literally.

 

[josebd]

how would it fix it?

 

[memilanuk]

Less slop in the machining, less tolerance stacking, more likely that the barrel points somewhere closer to center when everything is tightened down.

 

[josebd]

ok i will give it a try

 

[memilanuk]

Reach out to NSS and talk with them about what you're dealing with. See what they think. Maybe they'll have a different opinion.

 

[josebd]

Reach out to NSS and talk with them about what you're dealing with. See what they think. Maybe they'll have a different opinion.

i just read about his recoil lugs and barrel nut,it really makes sense now,thank you very much sir
i have dealt with him before,ive ordered a few barrels from him

 

[SBS]

Just put a .010 or .012" shim (Brownells) under the front base and all will be good.

 

[josebd]

I did have a one piece base on it with a bushnellnengage scope,it seeemed to do fine,I might just go back with the one piece if I can’t find the problem with this leupold setup

 

[dstoenner]

View attachment 1505838

I think this is. Non linear camera lens. This typical for wide angle lens. It is called barrel distortion.

David

 

[josebd]

I found the problem, the front base I used from a different set, I accidentally ordered a set that was dual dove tail, the front base is what I used, I already had the rear base, found another front base and it’s definitely a little thicker, now it looks like that fixed it, I’m getting ready to resight it in

 

[josebd]

That fixed it,thank you guys!

 

[Outwest]

Good deal!!