ADG 7 PRC in hand

[rhovee]

Myself and @Alex Wheeler got some ADG 7 PRC brass recently. Wanted to share some measurements.

Necks are spot on and loaded round is .3135. This gives .0045 neck clearance.

Case head measures .529

Volume of unfired brass is 79.89 grains with water.

I have had a few 7/300 WSM’s and this seems pretty similar case volume. The 7 PRC is longer, but case head is narrower.

 

[SKWERLZ]

nice!
If it performs like my ADG 7 saum brass you’ll be quite happy

 

[6.5 forever]

Myself and @Alex Wheeler got some ADG 7 PRC brass recently. Wanted to share some measurements.

Necks are spot on and loaded round is .3135. This gives .0045 neck clearance.

Case head measures .529

Volume of unfired brass is 79.89 grains with water.

I have had a few 7/300 WSM’s and this seems pretty similar case volume. The 7 PRC is longer, but case head is narrower.

Good news.

 

[B23]

Myself and @Alex Wheeler got some ADG 7 PRC brass recently. Wanted to share some measurements.

Necks are spot on and loaded round is .3135. This gives .0045 neck clearance.

Case head measures .529

Volume of unfired brass is 79.89 grains with water.

Curious, have you by chance measured the Hornady 7PRC brass and if so how do those ADG measurements compare to the Hornady 7PRC brass?

Always appreciate folks taking the time to measure this stuff out and post it so thank you for that.

 

[rhovee]

I can grab a piece and also a piece of Peterson and compare them side by side

 

[B23]

I can grab a piece and also a piece of Peterson and compare them side by side

That'd be great. No rush, just curious how it all compares to one another. The neck thickness on the ADG is right around .0145 +/- half a thou, is that correct?

 

[rhovee]

Sure is.