A couple of barrel cleaning equipment tips

[Uthink Uknow]

Can you beat FREE, boys and girls? I get these at the Servall Appliance Repair shop and they are full of oil. Put the oil in another container and use the Long Spout oiler as you wish. You can extend it to the length you need or cut it off where you wish. No muss, no fuss. Picture with various containers with the spouts extended. They have all been cut to an arbitrary length.

 

[TrapperBR549]

I recently got the bigger squeeze bottles from MidwayUSA IIRC, the smaller ones with blue top just don’t hold up well, after few months the blue plastic tops disintegrated exposed to chemical solvents

View attachment 1442273

91% Vodka, as in 182 proof?

 

[Danley]

View attachment 1442273

Russian Vodka

 

[Fast14riot]

I also use these for adding water to cases for checking H2O capacity.

For dispensing bore cleaning solvents I use these https://gauntindustries.com/

They have options on the ID of the needle so you can use the best one for the viscosity of the liquid.

I use these hypo-applicators at work all the time and at home. I use them for solvent cement when fabricating with plastics. A 25g needle is good for anything water-thin. Little tip when using these, fill no more than half way, squeeze the bottle with tip pointing up, release and then turn over, now the solvent won't run out uncontrolled, just a light pressure to stop it from sucking air in and you can apply very small, precise amounts.