7mm SAUM Reamer Diagram

[Walkabout]

Hi Guys,
Does anybody have a drawing/diagram of a 7mm SAUM reamer?
I have a SAAMI drawing, but I would like to see one from a reamer maker if any body has one?

Thanks
Mark

 

[Chrisjan]

I dont have an print available. But a loaded round with Norma 7mmRsaum brass measure .294 this gives you some insight when choosing neck diameters. I spec my reamers with 0free bore and then throat for a spesific bullet.

 

[WSnyder]

I dont have an print available. But a loaded round with Norma 7mmRsaum brass measure .294 this gives you some insight when choosing neck diameters. I spec my reamers with 0free bore and then throat for a spesific bullet.

You sure about that .294" dimension? That's only .010" over bullet diameter, .005" wall thickness with zero clearance. .294" is closer to what a 6.5 may use.

 

[WSnyder]

Reamer for single shot or long action, Remington neck turned brass and 7RSAUM Redding dies. It may not work properly with other brass or dies. Throat longer as needed.

 

[Walkabout]

Thanks guys
And thanks to WSnyder for the diagram.

Mark

 

[BOB LEE SWAGGER]

I dont have an print available. But a loaded round with Norma 7mmRsaum brass measure .294 this gives you some insight when choosing neck diameters. I spec my reamers with 0free bore and then throat for a spesific bullet.

ARE YOU KIDDING POSTING A .294 NECK!!! A NO-TURN FOR 7 SAUM IS .319!!!

 

[Chrisjan]

My apologies, was thinking of something else. I ment to say .314 loadad round on the Norma brass.

Sorry for my catastrophic mistake...