Citysmasher
My question is
WHY?
Not one person has stated that running the diameter close improves accuracy.
So, why do it? Why go to a new reamer at all? To save that tiny little bit of working the brass? It seems like a real pain and not at all consistent for the "no turn neck" crowd to figure out what reamer goes with what brass.
I think I would rather just let the brass wear out sizing that monster gap of an extra .0015" than mess with all the confusion.
WHY?
Not one person has stated that running the diameter close improves accuracy.
So, why do it? Why go to a new reamer at all? To save that tiny little bit of working the brass? It seems like a real pain and not at all consistent for the "no turn neck" crowd to figure out what reamer goes with what brass.
I think I would rather just let the brass wear out sizing that monster gap of an extra .0015" than mess with all the confusion.
