.308 185 gr @ 2700 fps good enough for 1000 yds?

[Keith Glasscock]

Remember to cross check which case they are using for their data. It makes a huge difference!

I'm using Winchester brass (same as Hodgdon uses) and their data correlates well with my rifle.

I would have to back down a little (or quite a bit) with Lapua.
Remington is close from what I've tested to the Winchester cases usually runs within .2 to .5 grains difference in charge to get the same results. Federal is a rule unto itself. If you run that, I'd strongly suggest that you take a close look at Sierra's data (done with Fed brass).

Be safe,

 

[Heavies]

I'm working on a load with the 185 btlr with IMR 8208 XBR. Just a work up to slight pressure and found the velocity needed (2730-50's). Got up to mid 2800's before a very light ejector mark. Hopefully accuracy will be found in this 2750 node.
Got some impressive numbers out of a 30" Bartlien 5r. 155 SMK Palmas were scary fast with this powder.
This is using Lapua small primer brass.