I have started working up a load for a 30 nosler.
Retumbo
Berger 215
Federal match magnum primer
Nosler brass
started very low and found the best node at 85.5 grains seated about .015” off the lands. First 4 shot group was .74” at 100 yards and the 2nd group of 4 was .8” at 100. Shot both of these on days where the temp was 92-98 degrees. I have a slight ejector mark on my brass. I would still like to fine tune this load to see if it will tighten up some more. What do you guys think? I’ve shot 86 grains and started getting a sticky bolt lift. I haven’t found any of the lower grains to show anything promising. Not the best picture
Retumbo
Berger 215
Federal match magnum primer
Nosler brass
started very low and found the best node at 85.5 grains seated about .015” off the lands. First 4 shot group was .74” at 100 yards and the 2nd group of 4 was .8” at 100. Shot both of these on days where the temp was 92-98 degrees. I have a slight ejector mark on my brass. I would still like to fine tune this load to see if it will tighten up some more. What do you guys think? I’ve shot 86 grains and started getting a sticky bolt lift. I haven’t found any of the lower grains to show anything promising. Not the best picture