22br

[stratboy]

I have one more question if i get my 22br remington rechambered to accept 22br lapua brass can i use my same 22br remington full length sizeing die or do i need to buy a die for the lapua cases and if so what dies do i try to find thank you

 

[rockhound78]

I use the same dies

 

[padom]

I would get a new die. They are different. Compare the prints.. norma chamber is bigger

 

[stratboy]

Is there anyone that sells the brass already formed for lapua 22br

 

[padom]

Is there anyone that sells the brass already formed for lapua 22br

I shoots tons of 22br lapua. It's super easy to make. Most just drop the correct 224 diameter bushing in a FL bushing die and size down all in one step without issue.

I personally grab a bushing size in the middle and size down half way, then size a second time with my final 224 bushing then run a mandrel into the neck and go shoot.

Stupid accurate and brass lasts forever. I have some over 30 firings that started out it's first 12 firings as 6br before I necked down to 22br...

 

[stratboy]

I shoots tons of 22br lapua. It's super easy to make. Most just drop the correct 224 diameter bushing in a FL bushing die and size down all in one step without issue.

I personally grab a bushing size in the middle and size down half way, then size a second time with my final 224 bushing then run a mandrel into the neck and go shoot.

Stupid accurate and brass lasts forever. I have some over 30 firings that started out it's first 12 firings as 6br before I necked down to 22br...

I have a reading 22 bench. Rest Remington die always work in that

 

[stratboy]

I have a reading 22 bench. Rest Remington die always work in that

Will these bushings work in my die