221 Fireball Chamber Question

[promach]

Can you cut a 221 Fireball chamber with a 223 reamer? I could probably figure this out, but since you knowledgeable guys are out there, just thought I'd ask.

 

[Preacher]

It's doubtful that the .223 reamer would be able to be run in far enough to get the base of the 221 the right diameter without going to deep...

 

[jscandale]

No, you cannot. The body taper is altogether different and would not allow a 221 case to fit into a short chambered 223.

JS

 

[promach]

Thanks Guys, I appreciate your input.
Know anyone who has a 221 reamer that they would sell or rent? I have 36 yrs experience in the machining business and a Hart barrel that cuts like butter. I'd like to get away without having to spend $100.00 bucks on a one time project.

 

[Preacher]

Buy one from Dave Kiff, do the job, and then sell the reamer, you'll only be out less than $50.00 at the most..
It will be set up for the exact bullet you plan on using.....

 

[jscandale]

Elk Ridge reamer rental is also a good resource especially if you are going to use it once. I have rented from them and the reamers have been sharp. He uses Pacific reamers.

JS