11 mm dovetail stock

[jmm03]

Hello all, I have been looking for awhile for a length of 11 mm dovetail stock to mount an anshutz reciever sight to a rifle. I can find all sorts of adapters that go from 11mm female to weaver etc.,but nothing in just a plain 11 mm rail. Is there just no such animal? I am able to make one if necessary but I was hoping for the easy route. Thanks, Jim

 

[hotrodlouie]

Good timing looking for the same thing. Found this / 11mm dovetail to Weaver or Picatinny on Amazon .com

 

[Outrider27]

Pyramyd Air's site seems to be down, but if you check them out and any other airgun sites you can find, one of them will have the rail you're looking for. I believe the one I got came from Pyramid.

 

[jmm03]

Thanks guys but what i'm looking for is not an adaptor but a piece of 11 mm rail, similar to the picatinney rail that is available to make one's own custom scope or sight mount. I have been to the pyramid air site before,i'll look again,thanks. Jim

 

[t.willis]

I have been looking for the same 11mm rail. No luck. I, too, would appreciate any info on finding this type rail.
Thanks.

t.

 

[superlight93]

Check Brownells

 

[Leeman]

Brownells sell the 3/8" stock rail but not 11mm. You can also get from Anschutz suppliers, the 11mm dovetail on a rail designed to increase the height of the factory machined Anschutz dovetail, but then you'd have to profile and drill to suit the action you intend to fit it to. I've also been looking for an 11mm rail and think I will end up getting an aluminium weaver rail already profiled and drilled for the action and just get an engineer or gunsmith to mill it down to the height I want and run a 60 degree dovetail cutter along both sides centered up on the drilled holes. Seems easier than starting from scratch or profiling the Anschutz item.

Richard.