Marks on bottom of base on scope

[markT]

my QD mount for thermal.

 

[Coyotefurharvester]

Mark has a pic of the type rail mount needed(AR ). But the scope base needs cross bolts that fit the cross slots. The cross bolts are than torqued when "pushed" forward in the cross slots. I can pm the QD info.
Marks on base are the result of sliding on the rail top(back/forth) during recoil.

 

[Pres100]

You need a new rail with slots all the way across the top. Your base “key” has nothing to grab.

I would agree with this.
It does look like the base key might be replaceable (by undoing the three Allen screws). Might call sight mark regarding that. Also may need to make sure the other two marks in the base are filed down flat before remounting

 

[josebd]

Not a great pic for me
So, why do the torx head screws look buggered?
Maybe it’s the pic

There not

 

[josebd]

I sold the wraith, I’m going with a agm adder thermal

 

[joshb]

There not

I think you’ll be fine with just buying a new rail.

 

[josebd]

Mark has a pic of the type rail mount needed(AR ). But the scope base needs cross bolts that fit the cross slots. The cross bolts are than torqued when "pushed" forward in the cross slots. I can pm the QD info.
Marks on base are the result of sliding on the rail top(back/forth) during recoil.

That makes sense

 

[joshb]

I sold the wraith, I’m going with a agm adder thermal

Well, now you can just use regular rings and keep the rail.

 

[markT]

You will need to remove the 3 socket head cap screws with a hex wrench and remove the burr on the "cross piece." The Torx screws are "anti tamper" and I don't see any reason to remove them.

 

[josebd]

I removed the burrs