Savage Chassis + Anschutz Rail?

[dc.fireman]

Hello all -

I am in the process of building a 300M rifle, using a Savage 12 SA (4.27"). I am looking for information on who might make a chassis that has an Anschutz styled rail built in, or easily added to it? If anyone here has any ideas, I greatly appreciate the tip.

 

[Albany Mountain]

I would go Elisio Chassis.. www.gotxring.com

 

[dc.fireman]

I've looked at the Eliseo models; but does/can it have an Anschutz rail installed in it? I don't care for the MEC styled hand stop/ sling point on the Eliseo; I would prefer to keep using the 4751 version I currently use across all of my position rifles.

 

[keithlhatfield]

I plan to route one (15” Anschutz Accessory Rail) into the Mark 12 Fore-stock. I bought a used Rear Floodplate and Front Swivel screw to retread and cut down to fit in slot of accessory rail. Wish me luck.

 

[dc.fireman]

I ended up with this.

 

[dc.fireman]

I plan to route one (15” Anschutz Accessory Rail) into the Mark 12 Fore-stock. I bought a used Rear Floodplate and Front Swivel screw to retread and cut down to fit in slot of accessory rail. Wish me luck.

Sunday GunDay: Old Savage Becomes 300M Match Rifle « Daily Bulletin

Editor: This story by Tommy C. (aka dc.fireman) comes from our Shooters' Forum. It's fascinating to see how a relatively inexpensive Savage M12 BVSS varmint rig was transformed into a sophisticated 300M match rifle with a modern cha...

bulletin.accurateshooter.com

 

[MGYSGT]

Have the local smith cut a channel in the stock and install the rail. I do it on all my prone guns.