Tuner for a 1.023 barrel.

[butchlambert]

I have a Harrels Tuner, which I had bored out to 26mm ( 1.0236" dia)

No problems with the clamping screws.

This was to fit a Walther KK500

Harrels told me no. I think I have it covered though.

 

[memphistransplant]

These guys sell tuners for rimfire.

Adaptive Tuning System - ATS - Short Action Precision

Adaptive Tuning System (ATS) New Tapered Version! This version accommodates larger barrel contours while maintaining a closer fit to the barrel to avoid catching it on barricades or external objects. Supports barrels up to 1.08" diameter approximately 2 inches behind the muzzle. Developed by...

www.shortactionprecision.com

 

[Silvermachine]

Harrels told me no. I think I have it covered though.

Harrels told me No as well , but it works.

 

[butchlambert]

These guys sell tuners for rimfire.

Adaptive Tuning System - ATS - Short Action Precision

Adaptive Tuning System (ATS) New Tapered Version! This version accommodates larger barrel contours while maintaining a closer fit to the barrel to avoid catching it on barricades or external objects. Supports barrels up to 1.08" diameter approximately 2 inches behind the muzzle. Developed by...

www.shortactionprecision.com

Their big one fits a 3/4" barrel, way too small.

 

[memphistransplant]

Their big one fits a 3/4" barrel, way too small.

Sorry, I think I gave you the wrong link. They say they support up to 1.08" diameter barrels.

https://www.kineticsecuritysolutions.com/products/adaptive-tuning-system-ats?variant=32154839941235

 

[dickn52]

Got one sitting here doing nothing that has an ID of 1.037. It was made for me by a local technician. Harrels I think.

 

[butchlambert]

Sorry, I think I gave you the wrong link. They say they support up to 1.08" diameter barrels.

https://www.kineticsecuritysolutions.com/products/adaptive-tuning-system-ats?variant=32154839941235

You may need to read it a little closer. It uses either 5/8 or 3/4 threads with a sleeve that slides over up to a 1.080 diameter barrel. I think that I said that I will not thread my barrel. I will use one of my Shadetree Eng. tuners.
Thanks guys

 

[mattt]

Mike Ezell made a tuner for my 1.045 Finnish valmet