Pressure problems

[Cskelsey]

I have a savage with a prefit 6.5x47 Lapua shot it earlier and had a sticky bolt no signs of pressure I backed the load down even more and still have a sticky bolt any help would be greatly appreciated

 

[Poor Shot 65]

Might not be pressure. Might be that the brass is too large for the chamber and is getting stuck. Measure your brass and compare it to your chamber specs ? This happened to me.

 

[garandman]

Is this virgin or sized brass?

 

[Uncle Ed]

To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.

Accept third party cookies

To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.

Accept third party cookies

To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.

Accept third party cookies

 

[Cskelsey]

Virgin brass

 

[Cskelsey]

No sticky lift just sticky when pulling bolt back with a fired piece of brass

 

[RetiredArmy]

Have you changed bolt handle? (After market) I did once, had primary extraction issues.
Went back to factory handle, problem solved.
Thanks Bill

 

[J.d. Popkes]

No sticky lift just sticky when pulling bolt back with a fired piece of brass

Primary extraction, out of time. I’ve had a couple issues with this. Couple ways to check/fix this. Made me pull my hair out until discovering it.

 

[Uncle Ed]

Read the links below, and try putting a .020 feeler gauge as shown in the photo below and see if it fixes the problem. The bolt may have been ground improperly and you do not have enough primary bolt lift. If the feeler gauge trick works then the bolt handle is defective and you do not have enough camming action to break the fired case free of the chamber.

Primary extraction site:savageshooters.com
https://www.google.com/search?q=Pri...AhUBSN8KHX00DCcQ8NMDegQIDBBB&biw=1366&bih=602

 

[J.d. Popkes]

What Ed said.

but ya can machine the bolt body to move the handle forward. Or machine set screws in your baffle to move it rearward. Machining the handle might be an option also. Just gotta get those two little wedge/ramp thingys to do their thingy. And they gotta contact each other to do said thingy.

 

[Cskelsey]

Noticed the problem after a block and single shot follower was installed could this have anything to do with it

 

[stacy]

TAKE IT OUT AND CHECK IT MAKE SURE THERE NOTHING BINDING UP WHEN THE ACTION SCREWS ARE INSTALLED

 

[olddav]

Noticed the problem after a block and single shot follower was installed could this have anything to do with it

Any witness marks on the follower? Does the bolt stick when cycling unfired rounds or empty brass?

 

[Cskelsey]

The bolt works easy with an unfired round

 

[J.d. Popkes]

Bro........

 

[Cskelsey]

Thanks for all your help and input I’ll look into it closer

 

[TimS]

How is it possible to watch Uncle Ed’s first video without being too distracted to comprehend?? Really, put a bandaid on it!