WTB 6-6.5x47 die set

[Bill Bowers]

Just got a 6-6.5x47L and was going to order a die set. Figured I see if anybody had a set they want rid of first. Redding, Forster or Whidden preferred.

Bill Bowers

 

[ASbobcat]

Just got a 6-6.5x47L and was going to order a die set. Figured I see if anybody had a set they want rid of first. Redding, Forster or Whidden preferred.

Bill Bowers

Bill,

I have a Redding 6x47L body die ANIB that I would sell for $33 shipped to CONUS. I checked Brownells, Midway and Grafs and they all want $39 +S&H.
Had to abandon my project for lack of funds.

Bob

 

[4xforfun]

Bill,

I have a Redding 6x47L body die ANIB that I would sell for $33 shipped to CONUS. I checked Brownells, Midway and Grafs and they all want $39 +S&H.
Had to abandon my project for lack of funds.

Bob

A body die and a bushing neck die is the ticket!!! Simply run the 6.5 brass into the body die and the necks will be real close to 6mm without the dreaded "bell". Simply neck size to taste and let simmer!!

The down side to a body die vs a FL die is that you will always have to size your brass in two steps if you need a FL sizing. Never bothered me a lick, but , I am a little "off"!!

Good luck,
Tod

 

[Bill Bowers]

Bill,

I have a Redding 6x47L body die ANIB that I would sell for $33 shipped to CONUS. I checked Brownells, Midway and Grafs and they all want $39 +S&H.
Had to abandon my project for lack of funds.

Bob

I found a die set with a FL bushing die but I would like to buy your body die. How do you want paid? I can do PayPal gift, money order or personal check. I will need a mailing address too.

Thanks,
Bill Bowers
448 S 8th St
Chambersburg, Pa 17201

 

[ASbobcat]

I found a die set with a FL bushing die but I would like to buy your body die. How do you want paid? I can do PayPal gift, money order or personal check. I will need a mailing address too.

Thanks,
Bill Bowers
448 S 8th St
Chambersburg, Pa 17201

PM sent

 

[ASbobcat]

SOLD pending funds