XP-100 trigger

[tgonza]

I have an XP-100 with a center grip trigger & .223 barrel. I believe the barrel is aftermarket as there are no markings on it. It does not have a recessed crown but is simply faced flat. I would like to remove the barrel and chuck it up in my lathe to do an 11 degree crown. I also want to chamfer the inside of the chamber as the shells hang up on the lip of the brass when chambering. The problem I have is I don't know how to remove the trigger and want to know if the recoil lug has a pin as it looks like it has to be reassembled in the exact same place as the trigger appears to attach to it.

 

[Dans40X]

Push the 2 each pins out of the receiver locating the sear group.
Remove the 2 each trigger group screws from the housing/recoil lug.
Remove the counterweight mid field in the transfer bar.

The recoil lug is not pinned to the receiver as it's design is the same as any Remington.
The recoil lug will require indexing upon barrel re-installation.

 

[tgonza]

Thanks, I'll give it a try this weekend.

 

[Preacher]

Remove the stock, use a barrel block, and a internal wrench and remove the barrel...
No need to do all that other stuff....