Winchester match primer

[Iowa Fox]

Primers were loose and falling out. They said send them some. They said it must be the brass. Sent them some of their brass. They said it must be me. I told them they could take their stuff and ---------------. When they sent the sleeve of primers back they did not tape it shut. The UPS driver asked what was rattling in the box. Opened it and 1000 primers were all loose.

I had the same thing but I didn't send them back. I was finishing a brick of Winchester L R and got out a new brick. New brick of primers was fall out loose in the same lot of brass. I Measured the diameter of the primers and the new measured way below published spec. for LR. I dug out a brick of CCI and they were nice and tight seated in the same lot of brass. Plus they measured what they should measure. I see a lot of fired brass on the ground at the ranges missing primers, yep Winchester head stamp. Best thing is just send them a financial message, DON'T BUY THEIR JUNK. Let the arrogant CEOs see it on their bottom line. Support the folks that support us, Remember the match sponsors and the good folks that donate to the prize tables.

 

[PatMiles]

Yup, they were purchased when the 205M cost me $100 per case of 5,000. A long time ago, I guess I'm a hoarder!

And proud of it!

 

[JimPag]

It’s a joke I guess you don’t understand jokes. Oh well I’m not here to argue with people.

No I guess I'm not the only one either.

 

[Bottom Fodder]

I’m use them mainly in my Contenders their like Federal softer than CCI that is why I use them but as most know soft primers can be a problem with a hot load