Wilson neck sizer modification

[mshelton]

I'm doing my neck sizing with a Wilson neck die and it will only size a little over halfway down the case neck, this is perfect for flat base short bullets but I'd like to get the whole or the majority of the neck sized for longer VLD bullets.

Does anyone know where I could get this die modified to allow me to do that?

 

[STS]

What case are you sizing? If I remember correctly, Wilson would do that for a fee. I'm not sure if they still do that or not. There are other options if they don't do that now.

 

[fdshuster]

Contact Wilson. They will modify their dies for a very reasonable cost with a quick turn-around. They opened up my 6ppc seater die when I went from a .262" chamber neck to a .272".

 

[JohnMill]

You could go to Neil Jones Custom Products. The micro dies have the advantage of being shoulder bump dies too (or not as you wish). Also being one of the 2 most accurate (for runout) dies that I used. The other was the Wilson

JohnMill

 

[mshelton]

Contact Wilson. They will modify their dies for a very reasonable cost with a quick turn-around. They opened up my 6ppc seater die when I went from a .262" chamber neck to a .272".

I had no idea they would do a seater die for a specific neck size, gotta say I'm pretty happy to hear this.

And I'll check with them on the modification, thanks.