Wilson chamber type seating die blank

[HoytFlinger]

Who would you recommend to ream by seating die blank using my chamber reamer? I've put a message in to Dave Bruno, but nothing yet from him.

 

[Preacher]

The guy that did your chamber would be your best bet....

 

[HoytFlinger]

The guy that did your chamber would be your best bet....

Gun isn't ready yet and the smith that is going to build it doesn't do dies he says.

 

[brfun]

What chambering are you having done? I ask because if I couldn't get the die cut the the reamer I got the chamber cut with then I would just buy one pre made if possible and have Wilson do any fitting that might need to be done.
Brian

 

[HoytFlinger]

The reamer is mine. So no worries there. It is a 300 Norma Mag.

 

[brfun]

I only wish i had bought more of my own reamers. To answer you question i would use you reamer to cut you die. I have had a couple cut for me this way and it worked good for me.
Brian

 

[HoytFlinger]

I found a smith, Eddie Harren, to ream it with my reamer.

 

[thumper4fun]

Might want to give your next chamber job to Eddie too since he will cut your dies for you.

 

[HoytFlinger]

I sent him a message concerning the build.