Which scope base for Anschutz 1913 Super Match

[praveen]

Hi,
I am trying to find a scope rail for an Anschutz 1913 Super Match (walnut). I see that DIP has a couple of 54 rails but the description says that they won't fit the square or match 54 actions.
MWorks also have rails but their description says they're for 2013 so I'm not sure if they'll fit the 1913.

Any Anschutz gurus here, please help.

-Praveen

 

[Jose_Luis_G]

Both 1913 and 2013 have the same rail, which is known as standard 11 mm.
If you find any for 11 mm, it will be good for you, no matter what the rifle is.

 

[jbell]

https://www.diproductsinc.com/Detail.aspx?PROD=1205469&CAT=3599

I have used them many times, order with set screws...

 

[praveen]

Thanks for the info guys !

 

[patriot]

Thanks for the info guys !

If you are shooting off the bench the short rail may work. For prone the Champion Shooters rail is best, particularly if you want the scope to return to zero after you take it off. If you are planning to use weaver size bases, these inserts work well.

Mark

http://www.championshooters.com/ind..._id=183&virtuemart_category_id=176&Itemid=111

http://www.ebay.com/itm/11mm-Doveta...521132?hash=item3f4a4d52ec:g:iWgAAOSwRLZUBicA

 

[praveen]

So, lets see if I understand this right. The champion shooters rail essentially is 11mm to 11mm but is longer. And the scope returns to zero because the whole rail is taken off instead of the rings? Is that correct?
That would work great because I want the flexibility of putting a scope as well as open sights.

 

[patriot]

So, lets see if I understand this right. The champion shooters rail essentially is 11mm to 11mm but is longer. And the scope returns to zero because the whole rail is taken off instead of the rings? Is that correct?
That would work great because I want the flexibility of putting a scope as well as open sights.

Yep, you got it. And if you shoot 3P you can adjust the eye relief for each position.

Mark

 

[praveen]

Thanks ! I ordered the champion shooters rail.

 

[Fotheringill]

Be careful if you get the long rail. If you mount your scope further back than "normal", the front of the rail is going to contact the rear part of the objective bell. I did this. I then had to use a metal saw to cut off some metal from the front part of the rail.