Where'd my chamfer go ?

[garandman]

I chamfer the inside of the case neck for every rifle load. Then I FL size each case every time.

My chamfer always disappears to a squared off case neck.

Is FL sizing crushing down the chqmfer ?

 

[Gappmast]

I'll bet if you can find where the missing socks go you will find the chamfer

 

[acloco]

FL size, THEN lightly chamfer inside and outside of the case mouth.

 

[rsmithsr50]

hmmmmmmmm
anneal
fl size with a bushing
trim to length
chamfer in and out

 

[rsmithsr50]

are you pulling a button thru the neck ?
presto magico disappearing chamfer

I chamfer the inside of the case neck for every rifle load. Then I FL size each case every time.

My chamfer always disappears to a squared off case neck.

Is FL sizing crushing down the chqmfer ?

 

[Old Navy]

I'll bet if you can find where the missing socks go you will find the chamfer

Erma Bombeck used to say there was a sock heaven. lol

 

[Brians356]

If your chamfer disappears that readily, you must not be over-chamfering with a Giraud.
-

 

[Burnt Powder]

I chamfer the inside of the case neck for every rifle load. Then I FL size each case every time.

My chamfer always disappears to a squared off case neck.

Is FL sizing crushing down the chqmfer ?

You using an RCBS dead length die?

 

[dellet]

Your sizing ball steals it

 

[jonbearman]

Brass stretches more than you think. I tumbled some in pins and dawn etc and my small chafer was gone almost. Everytime I load I touch them up with a VLD type tool.

 

[PatMiles]

Your sizing ball steals it

Damn sizing balls! There ought to be a law.

 

[Old Navy]

I only chamfer new or once fired factory. Should I be doing it more often?

 

[Richard Coody]

I only chamfer new or once fired factory. Should I be doing it more often?

Whatever works.for you.

Now i don't tumble.my cases wet or.dry. After sizing a case i clean primer.pockets with a crockagator, lightly brush out neck, run a wilson depriming pin through the flash hole to ensure its clear and do a light chamfer & debur with a hand tool. While doing so i examine the condition of the case.

A little.time.consuming but i enjoy reloading and want to take care of my carefully prepared brass.

 

[PopCharlie]

I'll bet if you can find where the missing socks go you will find the chamfer

The missing socks morph into Tupperware lids that fit no container you own.

 

[dgeesaman]

I chamfer the inside of the case neck for every rifle load. Then I FL size each case every time.

My chamfer always disappears to a squared off case neck.

Is FL sizing crushing down the chqmfer ?

It’s hard to see these chamfers under the carbon, and if they still exist. So I steel wooled a few and at least in my case (pun intended) it was just obscured by carbon.

 

[NZ_Fclass]

Damn sizing balls! There ought to be a law.

I'll check with the Democrats - there may be one!

 

[sqrlgtr]

It’s hard to see these chamfers under the carbon, and if they still exist. So I steel wooled a few and at least in my case (pun intended) it was just obscured by carbon.

Wished you guys would quite talking about carbon them Demcrates get wind of it we will have a tax put on it to fund some grand project!