• This Forum is for adults 18 years of age or over. By continuing to use this Forum you are confirming that you are 18 or older. No content shall be viewed by any person under 18 in California.

What percent of taper on Dasher?

What percent of cartridge taper are you guys using with no problems in your Dasher's reamers?

For instance I would think as an example that 90 deg (no taper) would be a problem. I am looking for the least taper I can use without experiencing any difficulty that can't be overcome.
If you have experience in this area I would really appreciate what information you can provide.
 
Taper is figured by thousands of an inch, per inch, not percent. If my memory serves me .008" per inch is pretty common. It may well be more like .009" or .010". The dies are already made from a blueprint, you are wanting a min sammi .4714" @ the .200" line of the drawing to .460" at the shoulder. These numbers work and work very well.
 

Upgrades & Donations

This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.


Click Upgrade Membership Button ABOVE to get Gold or Silver Status.

You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.


To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.

Forum statistics

Threads
166,833
Messages
2,223,822
Members
79,930
Latest member
Chief Sitting Bull
Back
Top