What neck bushings for a 20VT with .233 NK/load data

[chappo555]

My Sako goes off to the gunsmith next week for a 20Vartarg barrel. I will be forming 221 fireball brass (remington obviously) and plan on using the Redding Type S match bushing die set .

My gunsmith is using a 20 Vartarg reamer with a .233 NK. So what bushings do you guys recommend?

Also would appreciate any load data for the 32gr and 40gr pills. I only have access to ADI (hogden to you guys) and Alliant. It will be a benchmark barrel 1:10 twist @ 24 inches finish length.

Thanks heaps guys
Chappo555

 

[ab_bentley]

Neck a round down and seat a bullet. Subtract .002" for single shot or .005" for repeater. You should run about .226" but it's best to seat a round and see for sure. Adam

 

[hedditch]

Mine is a .226 bushing.

 

[flatlander]

My loaded rounds measure .228"-.2285", so I purchased .226" & .227" bushings. Will play with rounds sized with both to see if one works better than the other.