VLD Chamfer Tool consensus

[rkittine]

I bought the VLD tool, probably because of the hype and me being an "Newbie" but it is now all I use. My Lyman Brass Prep machine even came with one rather than 45 degrees.

Bob

 

[deadduck357]

Send it to me I’m in need of a new sharp one

I'll keep it just to say I have one. Lol

 

[Jimmy James]

Got the $11 RCBS and did a test with some 308 boat tails and the groups got smaller. I dont have all the details in front of me but I'm a believer. Whether or not i would have gotten the same results with a 45 degree tool, i dont know.

 

[Richard Coody]

most people over chamfer.

 

[deadduck357]

most people over chamfer.

Yeah with these I can definitely see that happening... quickly.

 

[SteveOak]

I just use the old wilson rocketship. I have all the vld chamfer tools but they all seem way too sharp and cut too much. the best one is the K&M if you want a vld tool though.

I don't have the ability to control the depth and angle as much as I would like when hand holding the deburring tool so I use the Wilson version that is used with the case trimmer.

 

[Ledd Slinger]

most people over chamfer.

This is where the K&M shines with the built in adjustable stop. Set it to take off just enough for smooth seating and the depth remains exactly the same on every case.

http://kmshooting.com/case-neck-cha...epth-tapered-reamer/large-6mm-338-reamer.html