Very little talk of LT32?

[urbanrifleman]

This was supposed to be the new Vit n133 killer. What happened?

 

[johara1]

LT 30 shoots better....... Jim

 

[DOGCAPPER]

LT 32 is available. On my 3'rd 8#er.

 

[LHSmith]

Lots The first 2 lots worked well in a lot of ppc's- the subsequent lots-not so much.

 

[urbanrifleman]

LT 30 shoots better....... Jim

Just across the board?

 

[Tim Singleton]

This was supposed to be the new Vit n133 killer. What happened?

It's used by a lot of guys in a ppc.
A lot of guys use it as much as 133

 

[WyleWD]

Wo

It's used by a lot of guys in a ppc.
A lot of guys use it as much as 133

+1 and we've been really impressed with it in 6br using 10-12 twist with 68gr bullets in 100-200yd too. WD

 

[R.Morehouse]

I love the stuff. Replaced 133 in my room.....

 

[Dave T]

I pierced a 205M primer using LT30. Anyone else have this problem?

 

[BartsBullets]

I pierced a 205M primer using LT30. Anyone else have this problem?

Lt 30 is pretty HOT. How much were you shooting.

 

[Greyfox]

I compete in score matches with a 6 PPC, 6 Beggs and 220 Beggs. I wouldn't even consider anything else. use LT 32 in all three.

Rick

 

[Dave T]

Lt 30 is pretty HOT. How much were you shooting.[/QUOTE)
Bart, I was using LT-30 in my old Sako 6PPC USA single shot varminter and I think it was 26.5 grns and I was using one of your bullets, I think a 66 grn Ultra, but this happened just one time and I switched to remington or cci primers and it never happened again.

 

[BartsBullets]

Dave,

As a general rule I’ve found Lt30 to run 1 grain hotter than LT 32 and 2 grains hotter than V133. Federal primers are some of the softer ones.

I have disintegrated primers with Lt30.

Bart

 

[urbanrifleman]

Dave,

As a general rule I’ve found Lt30 to run 1 grain hotter than LT 32 and 2 grains hotter than V133. Federal primers are some of the softer ones.

I have disintegrated primers with Lt30.

Bart

Is one better than the other?

 

[BartsBullets]

Is one better than the other?

I’ve shot a lot of both powders. I personally prefer LT 30. Sometimes Lt32 quits shooting and I haven’t been able to pin point why.

Bart

 

[urbanrifleman]

I’ve shot a lot of both powders. I personally prefer LT 30. Sometimes Lt32 quits shooting and I haven’t been able to pin point why.

Bart

Interesting. So, I suppose they are both very similar then?

 

[BartsBullets]

Interesting. So, I suppose they are both very similar then?

I don’t know if Id use the word simular to describe them. Lt32 when it’s working is a thing of beauty. I’ve shoot some of my best aggs with it. But there are times I can’t get it too Work. Lt30 has always worked for me without any dead spots. But it’s hotter! Some shooters are mixing the two of them LT31. I haven’t tried it personally. You’ll like either one of them. They are a lot easier to stay on top of then 133.

 

[Prose]

LT32 is a powder that I've been thinking about using in my 20VT. Currently I use H4198. Rumor is you can get a couple hundred FPS gain with the LT32. Problem is, four pounds of H4198 lasts a really long time with this small cartridge!

 

[urbanrifleman]

Lt 30 is pretty uncommon out there in retail land. And pretty pricey too.

 

[rangertim]

But cheaper than 133