Transferability of Dillon powder measure between 550 and 750

[shamrock12]

I’ve verified that Dillon 550 and 750 uses the same powder measure and are interchangeable between those presses. If I want to transfer a Dillon measure say from 550 over to 750 for the exact same caliber/load, is there any readjustments I would need to make on the measure itself after transferring? Each press tool head will have its own powder die, so I would only be removing the split ring clamp on the bottom of measure prior to transferring.

 

[DDRanch]

Powder measure will work. But double check to make sure output weight is the same.

 

[MikeT124]

Should work just fine, you may need to do some minor adjusting on the die. Myself I would just buy another Dillon powder measure and keep them both setup for the load I'm using.

Mike

 

[nbkky71]

Transferring the powder measure won’t pose an issue but remember that the height of the powder die can effect its operation. It might take some tweaking on the 750 press