Time to bump the shoulders back

[JohnJ]

I have the neck bushing dies and am loading for the 6br.the cases are starting to get tight chambering and its now time to bump the shoulders back

now the question is, should i bump the shoulder back first then neck size or neck size first and then bump the shoulder back.

thanks guys

JohnJ

 

[Forum Boss]

LOL, this is why I use a Full-length sizing die with the neck honed to give about .0015" tension--one pass and I'm ready to load.

However, answering your question, if you are using a FL-die it's going to size your neck anyway, so you might as well size the case body first. If you are sizing the body with a body die, I would still probably do the body first. That way your neck-sizing is done on a case that is headspaced right, and the amount of neck sized might end up a little more consistent from case to case.

 

[JohnJ]

thank you for answering the question

JohnJ