• This Forum is for adults 18 years of age or over. By continuing to use this Forum you are confirming that you are 18 or older. No content shall be viewed by any person under 18 in California.

Tailstock test bar alignment mt3 tool

Those will get you semi close. Best way is the make test cuts and mic...then move accordingly. Repeat till bar cuts true.
 
ridgeway said:
Those will get you semi close. Best way is the make test cuts and mic...then move accordingly. Repeat till bar cuts true.
Click to expand...
test cuts with a piece of barstock with centers drilled in each end turning on centers in headstock and tailstock turned by a dog??
 
You must log in or register to reply here.

Similar threads

Chambering from tool post holder
Replies
16
Views
5,002
missed
Reamer alignment mounted on tool post.
2 3
Replies
40
Views
2,146
boltfluter
boltfluter
Mblmotors
SOLD NECO Concentricity Gauge and NECO Cartridge Alignment Tool $125 shipped conus
Replies
4
Views
524
Mblmotors
Mblmotors

Upgrades & Donations

This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.


Click Upgrade Membership Button ABOVE to get Gold or Silver Status.

You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.


To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.

Classified Ads

Forum statistics

Threads
166,885
Messages
2,224,750
Members
79,994
Latest member
George T

Share This Page

Back
Top