• This Forum is for adults 18 years of age or over. By continuing to use this Forum you are confirming that you are 18 or older. No content shall be viewed by any person under 18 in California.

Stuck brass (7mm08 hornady)

I don't like using the spray lube, but if you do, shake the hell out of the can to get the lube in suspension before you spray the cases.
 
Bought a stuck case remover when I bought my press in 1980, still haven't used it. I did use RCBS lube at the very start, added a Forster Dry lube neck brush kit to the sizing process PDQ after the start. Used that setup for 30 yrs, switched the RCBS lube to Imperial wax about 15 yrs ago, much nicer to use and cleanup than the RCBS lube is. Recommended the dry neck lube brush kits to anyone that asked, useful with neck dies, neck or FLS bushing dies, mandrels as well. Everyone that ever replied back on it liked it, it makes a difference, especially on using the stock die buttons, and doesn't contaminate powder. Some people say it wears dies and mandrels and etc, I have not found that to be the case, still using the same set of 7-08 dies I bought in 85, probably close to a barrel's worth of ammo now. You'd have to load a many thousands of rds to see any wear, and a new sizer or mandrel or bushing after that many rds, is no big deal.
 

Upgrades & Donations

This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.


Click Upgrade Membership Button ABOVE to get Gold or Silver Status.

You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.


To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.

Forum statistics

Threads
165,851
Messages
2,204,878
Members
79,174
Latest member
kit10n
Back
Top