spray silicone for sizing

[Campbell]

On steel to steel silicone grease/oil will screw you up. It will cause galling.

As far as re-sizing lube is concerned, I find the Lee stuff absolutely superb. I have to admit to not having used Imperial Wax though.

 

[Cecil S.]

I am a newbie and have not stuck a case yet.....yet. I neck down LC 308 and found Imperial every 4-5 cases with a dab of Lanolin worked for me. I could feel the difference in the press handle. Just sayin

 

[ireload2]

For normal use including most case forming I use Imperial.
For the worst case forming I use Mystik JT6 water resistant chassis lube that comes in a 14 oz green tube for $4.50. This is a colorless translucent grease that looks like a hair gel.
It really costs me nothing for reloading since it was purchased for lubing my 4WD front end.
While it is a much better case forming lube than Imperial it is kind of messy so it is used for one time case forming operations.

Lol, i have 2 Hornady dies in the junk/misc drawer now with ripped off rims ,used one shot
Granted its range brass that I would not put through Wilson or custom dies.
This stuff works like imp was and is good for your handsView attachment 1034024

 

[dolek]

My new favorite is Burt's bees cuticle cream...My fingers are dry and cracked so I was putting some on before resizing some brass so I gave it a whirl .I tested it side by side with Imperial wax,I felt no difference. Win/win in my book.