Solid Brass/ Copper Bullets at 1K

[Blaster-37]

Is anybody else messing around with CNC turned solid brass or copper bullets at 1000 yards with the 6mm Dasher? I have found some that have good promise. I am not sure of barrel wear, etc. I have found they like to be pushed hard.
I had good success with them in the larger calibers after exploring many shapes. Solid brass, in the right configuration for the barrel, consistently had a better group than the jacketed bullets at 1K. I would like to gather more hard information for the 6mm.
Thanx.
Greg

 

[FroggyOne2]

I know a guy that wishes he still had some Barnes Bore Riders.

 

[Blaster-37]

Of course I will monitor it with a borescope. Does a 109 gr 6mm with a confirmed BC1 of 0.747 get your attention? Getting a good cut barrel with a 1/6 twist is hard.
I can't seem to stay out of the deep end of the pond looking for a registered 1K 10X, it must be early cabin fever. Deep Creek fringe.
Greg

 

[johara1]

Greg, I think Tom is in the same boat, cabin fever......or maybe he bumped his head...... keep us posted...... jim

 

[itchyTF]

Bruce Baer has been using/involved with Cutting Edge Bullets. He may have some info for you.
http://www.baercustomrifles.com/

 

[johara1]

Tom, wait for a couple more months........ ......jim