matthias
Gold $$ Contributor
i am looking for input on a barrel vice that will hold a freaking factory barrel with out spinning. i have the wrenches and a wheeler barrel vice with oak blocks and rosin. i have tried to my patience end and i have decided there is a better way. i just dont have the answer at the moment.
very frustrated ,
i have done 93 removals and really dont have a set way of doing it
nine out of ten barrels will come off no issue . then there is the other one. i would rather cut the damn thing off but the customer still wants it.
how do you remove stubborn barrels?
what hardware do you use ?
really annoying because i have used all the tricks i know of
heating , cooling, kroil, wd40 , etc
very frustrated ,
i have done 93 removals and really dont have a set way of doing it
nine out of ten barrels will come off no issue . then there is the other one. i would rather cut the damn thing off but the customer still wants it.
how do you remove stubborn barrels?
what hardware do you use ?
really annoying because i have used all the tricks i know of
heating , cooling, kroil, wd40 , etc