Shot Marker / Shotmarker - Hub Firmware and Commands

[fincl]

Hi all, thank you for letting me join

I just had a couple of questions about the Shot Marker hub / MCU. I have been able to change Hub ID with the "ID=XX" command. I was hoping someone might have a list of other commands that can be sent to the hub for testing?

Unfortunately, I think that my hub's firmware has someone become corrupted due to some strange behaviour (hub ID changing by itself, multiple hub ID's shown on the webpage even though I only have the one sensor hub, random shot data being sent, gibberish symbols etc). Does anyone know if there is a way to update / re-flash the sensor hub or have an original / factory default copy they could provide? I am aware we can update the software but I don't think it updates the sensor hub, only the access point. I am generally pc-literate and able to plug things in to update firmware.

Many thanks in advance.
Chris.

 

[Mike Powers]

Sounds like there may be another shotmarker nearby on the same channel. Easy enough to change but not while near to the other one.

 

[paperpuncher]

If you can’t resolve the issue contact Adam at shotmarker He is generally quick to reply and will get you sorted out

 

[rlporter507]

If you can’t resolve the issue contact Adam at shotmarker He is generally quick to reply and will get you sorted out

this! if theres another SM in the area, I've found it works best to turn them all off, at least the sensor hubs. then the one you want to change channels on, turn it on, change the channel, then everyone else can turn theres back on.