Separated case neck

[Jeff Von Rosenberg]

Just went to load chamber on my T 2K and there appeared to be a separated case neck in chamber. Any suggestions for removal? Must have been last shot on prior session. These loads have never been hot! Thanks JVON

 

[Rem6br]

You might try a pick if ya have one, if you have access to a piece of tig wire
Sharpen the end then bend a very short 90 degree bend on the end and try
to grab it. Just an idea maybe someone else has had this happen before

 

[Erik Cortina]

Put an oversized brush on cleaning rod and put it half way in there, then pull out. When bristles reverse, they will catch it and pull it out.

 

[fdshuster]

Erik's method with a bronze cleaning brush will work. Just use a non-rotating cleaning rod like one for a pistol & turn it in a clockwise direction while pulling to the rear.

 

[Jeff Von Rosenberg]

Got it out! Wasn't a case neck it was a 1/8 piece of a Tubb bore guide!! By the way the over size bore brush worked, thanks JVON