Savage F T/R Check Rest. Pain to remove for barrel Cleaning. Better Fastner??

[Linko]

I own a Savage F T/R rifle with a plastic cheek piece. It uses a screw to fasten to the stock. Does anyone know of a fastner that I could use that is a 1/4 turn spring loaded affair? Something easy on easy off. I dont mind the fact the cheek rest is plastic, so I dont want suggestions to replace it with something else. Just the method it is attached.

 

[Taildrag15X]

Those Choate cheek rests, same problem on their stocks too....I had thought of using some thing from Southco, like a DZUS Panex, they have a ferrell type nut that should work.

http://www.southco.com/en-us/d8

 

[crowsnest2002]

You'd have to inlet a little for those I think.

 

[Linko]

Those Choate cheek rests, same problem on their stocks too....I had thought of using some thing from Southco, like a DZUS Panex, they have a ferrell type nut that should work.

http://www.southco.com/en-us/d8

I looked at those. I need 1 1/2 inch length. Havent found long ones. Thinking a shaft attached to the comb piece and drill a verticle hole in the stock with a spring on the bottom to take out the wiggle. Then a horizontal hole for a pin to go thru the shaft near the bottom of the shaft. I cant have anyting sticking out the top of the stock and still clear the bolt when it is being removed.

 

[minnesotamulisha]

I've got the same gun. I bought a Triad Tactical stock pack and put it on over the shorter of the cheek pieces. I can still remove the bolt while they both are installed on the rifle.

 

[Linko]

Someone suggested a snap like used on canvas. Might be a simple solution.