Savage action screw hole spacing

[longbow]

I have a AMT action,longer than a Remington.Outside screw holes are right near 5.1 ". 1.350 round action. can one of you guys give me measurements for a large savage action. I think the screw holes about line up. the action is not in my possesion right now. Thanks

 

[1911nut]

Here’s something

Savage Shooters - Savage Action Lengths

actions magazine action short generation screw spacing savage long series

www.savageshooters.com

 

[Texas Solo]

I once contacted Boyd's about a stock for a Savage 12 TARGET action. My #12 FTR 308 is a TARGET action. That means it's single feed with THREE action screws. Boyd's could not understand the question. I've yet to find ANY aftermarket stock or chassis for a THREE screw Savage action.

 

[riverwolf1]

The following measurements depict the various screw spacing on Savage 110 centerfire actions over the years. All measurements are center-to-center.

All Long Actions = 5.062" (1958 to present, staggered and center-feed magazines)
1st. Gen Short Actions = 4.522" (1959 to 1987, staggered feed magazine)
2nd Gen Short Actions = 4.275" (1998 to 2007, staggered feed magazine)
3rd Gen Short Actions = 4.400" (2005 and up, center-feed magazine, not in photo)
3rd Gen Palma/Dual-Port = 3.440" (2009 and up, single-shot only)
Axis/Edge = 4.800" (2008-present; spacing same for long or short action cartridges)

 

[rjtfroggy]

I once contacted Boyd's about a stock for a Savage 12 TARGET action. My #12 FTR 308 is a TARGET action. That means it's single feed with THREE action screws. Boyd's could not understand the question. I've yet to find ANY aftermarket stock or chassis for a THREE screw Savage action.

I have a McMillan 4.40 three hole. They had the print when they inletted it.

 

[Old Navy]

If you are willing to drill holes in your action you can easily make it fit the stock you have.

 

[22vartarg]

I once contacted Boyd's about a stock for a Savage 12 TARGET action. My #12 FTR 308 is a TARGET action. That means it's single feed with THREE action screws. Boyd's could not understand the question. I've yet to find ANY aftermarket stock or chassis for a THREE screw Savage action.

HS Precision make the stock that Savage uses I believe. The part number is

PSV106.​

 

[longbow]

Thanks guys! Got all I need.

 

[Rat Rifle]

I have a AMT action,longer than a Remington.Outside screw holes are right near 5.1 ". 1.350 round action. can one of you guys give me measurements for a large savage action. I think the screw holes about line up. the action is not in my possesion right now. Thanks

I would want all parts in hand before contemplating such an endeavor.
Just Sayin

 

[longbow]

Just roughing out......

 

[Taildrag15X]

If you are willing to drill holes in your action you can easily make it fit the stock you have.

Way better off drilling and using pillars in the stock.

 

[DHuffman]

I once contacted Boyd's about a stock for a Savage 12 TARGET action. My #12 FTR 308 is a TARGET action. That means it's single feed with THREE action screws. Boyd's could not understand the question. I've yet to find ANY aftermarket stock or chassis for a THREE screw Savage action.

McRees Precision

 

[1911nut]

yup, McRees

mine is the 3 screw Savage target action. Solid chassis but heavy.