Savage 22-250 hard extraction(update)

[josebd]

At the shoulder below the neck?the reloads measure the same as factory

 

[LCazador]

I think your problem is at the case head not the on the shoulder or your neck. I think what bolt fluter mentions above, is to measure .200" in front of rim and the same on a new piece of brass both Lapua cases of course. Your sizing die does not size this area but a small base die might help.

 

[josebd]

Ok,factory round measures .4645
Reload .464
Fired shot .465

 

[josebd]

Measured with micrometer

 

[boltfluter]

So, will the fired factory round chamber ok? Will your reloaded case chamber ok?

Paul

 

[josebd]

The fired factory rounds chambers with a little resistance, ejects good.
Reload chambers with less resistance than the fired round,ejects good.
The round I fired yesterday, bolt closes with some resistance, but wont eject?

 

[josebd]

The fired round that wont eject measures .465 .200 in front of rim

 

[josebd]

Small base die fixed it.it was tight right below shoulder,the die resized it more.

Thank you everybody, I know some of you guys suggested that,thank you