Sako Extractor Fitting PTG Rem 700

[HuntPA]

Hello - has anyone ever fit a PTG medium sako to a PTG 1 piece bolt? I picked up some diamond EZ Laps and got the sako smoothly fit on the bolt recess - however the physical length of the compressed PTG spring with PTG pin wont allow the sako to mate in to the hole. Curious if anyone whom has successfully performed this has next steps advice. Do I take a 0.104 inch hone to the spring hole?

thanks in advance,
regards.

 

[DaveTooley]

If the pin/spring combination won't compress far enough it's simple to drill the hole deeper. I'll bet it won't take much.
Without the spring and pin does the extractor fit and function properly? You can take a small screwdriver to apply pressure on the rear.

 

[HuntPA]

If the pin/spring combination won't compress far enough it's simple to drill the hole deeper. I'll bet it won't take much.
Without the spring and pin does the extractor fit and function properly? You can take a small screwdriver to apply pressure on the rear.

Without the spring and pin - it fits as it should -