RWS flashholes
- Thread starter Willie
- Start date
Dusty Stevens
Shiner
They should be very uniform being the best brass made and all. i wouldnt touch em.
nicholst55
Brass Whore
Have you got a set of numbered drill bits (0-60)? You can use those to measure them.
I could see enough burrs inside some random cases that I deburred them all. As well as I could tell, the .080" K&M deburring bit was not cutting inside the flashholes.
Just touching up the inside face a bit, as the K&M is adjusted to barely leave any bevel while removing a burr.
All cases were same lot, but 5 boxes, out of ten, were not as tight as the first boxes. I tried another tool that fit in the flashholes, but didn't use it because it had an aggressive bevel.
Anyway, they're all done, ready for false shoulder and forming.
Just touching up the inside face a bit, as the K&M is adjusted to barely leave any bevel while removing a burr.
All cases were same lot, but 5 boxes, out of ten, were not as tight as the first boxes. I tried another tool that fit in the flashholes, but didn't use it because it had an aggressive bevel.
Anyway, they're all done, ready for false shoulder and forming.
Upgrades & Donations
This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.
Click Upgrade Membership Button ABOVE to get Gold or Silver Status.
You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.
To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.
Click Upgrade Membership Button ABOVE to get Gold or Silver Status.
You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.
To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.