Ruger 77/22 Hornet

[PRR1957]

Trying to remove/unsrew a barrel from a Ruger 77/22 Hornet. Is there a special action wrench that fits into the reciver and If so, were could I get one. Brownell dosn't have anything for the Ruger's. If I had access to mill and lath I could make one. (Made one years ago for Remington's XP100/600/660/700/Model-7/40X.) I have an aluminum barrel block that will fit multiple barrel diameters.

 

[msalm]

I’ve just used a flat on the top and bottom, I added a strip of thicker aluminum on the top to prevent messing up the scope base. Or use the side flats and be sure the action wrench is tightened down parallel.

 

[matthias]

I use the Brownells brand Mauser wrench with 1/8 aluminum strip on the top of the receiver and a flat bottom

 

[PRR1957]

Thanks for the info.