Rl-26 140 nosler partition 6.5 creedmoor

[Mike6.5]

Hey guys going to see if any one had experience with this combo. Would like to have a safe starting point. If someone could please run a quickload that would be great too.
6.5 creedmoor
Nosler 140 partion
Peterson brass 50.2 water capacity
Rl 26 I also have imr 4451 and h4350
22 in barrel.
Not sure on coal but I would say somewhere around 2.875 or so. This rifle has a very long throat. I am going to try and pick up some bullets today so I will have a better idea on overall length tonight. I have been trying the 125 or but haven't been able to get them to shoot any better than about 1.5 so I thought I would try the 140. My gun shoots 120bt and 135 berger really well this will be the first 140 gr bullets I have tried. Thank you for any help.

Michael

 

[sbhooper]

Start about 46 grains and go where you need to. The top should be around 47+

 

[Mike6.5]

Start about 46 grains and go where you need to. The top should be around 47+

Thank you! That's we're I started got a good group with 46.2 will shoot again today. Also was righting back up at 47. Haven't seen any psi I signs going to go up to 47.5.

 

[sbhooper]

I think that you will be surprised at how low the sd is with this powder. The cm likes lots of powders, but for me, re 26 stands out with the heavier bullets. Re 15 works real well with the 129 Interlock that I shoot, for about 2800 fps. Incredibly accurate in my rifle.

 

[Mike6.5]

I think that you will be surprised at how low the sd is with this powder. The cm likes lots of powders, but for me, re 26 stands out with the heavier bullets. Re 15 works real well with the 129 Interlock that I shoot, for about 2800 fps. Incredibly accurate in my rifle.

I also noticed it didn't seem to me that the barrel heated up as fast with rl26 as it does with h4350.