jpattonr
Silver $$ Contributor
My grandfather is getting out of the shooting sports and is offloading quite a few items. From his workshop:
Feinwerkbau 300S stock, homemade laminate with great contrasting grain. The heavy lifting on this stock is done; inletted and glass bedded with bottom metal bushings for the receiver screws. It is a fixed cheekpiece stock designed for offhand or bench shooting. There were areas that he tried to clean up, but never got around to finishing it. In my opinion, an exterior sand and refinish would be a good plan. This is a vintage stock but will make a great FWB piece with some TLC.
There is some damage to the right side at the tip of the forearm of the stock as well as some small areas that need to be addressed, but nothing major, in my opinion. I have included measurements below:
Weight: 3lb 12.2oz
Overall Length: 32 1/2"
Approx Length of Pull: 12 1/2"
Forearm Width: 2 1/4"
Asking $125 shipped.
Feinwerkbau 300S stock, homemade laminate with great contrasting grain. The heavy lifting on this stock is done; inletted and glass bedded with bottom metal bushings for the receiver screws. It is a fixed cheekpiece stock designed for offhand or bench shooting. There were areas that he tried to clean up, but never got around to finishing it. In my opinion, an exterior sand and refinish would be a good plan. This is a vintage stock but will make a great FWB piece with some TLC.
There is some damage to the right side at the tip of the forearm of the stock as well as some small areas that need to be addressed, but nothing major, in my opinion. I have included measurements below:
Weight: 3lb 12.2oz
Overall Length: 32 1/2"
Approx Length of Pull: 12 1/2"
Forearm Width: 2 1/4"
Asking $125 shipped.
Last edited:
