Rear entry action wrench

[halfmoanut]

Looking to buy a rear entry action wrench for removing barrel with glued in stock. Bat & Stolle.

 

[Rustystud]

Call Kelblys They sell a rear entry wrench just for this $55.00-$65.00 range. Their Barrel vice is real good too.
Nat Lambeth

 

[Uthink Uknow]

http://forum.accurateshooter.com/index.php?topic=3762965.0

These are the best I've seen. They cost more than a Kelbly but have a lot more going for them. Like any custom action or gun build, there is more going into it. You can buy a Chevy or a Cadillac. Right Nate?

 

[3dogs]

+1 on Paul's tools

 

[SmokinJoe]

+2 on Paul's wrench

 

[doc gordon]

I have sent "pike" numerous emails explaining I would like to buy wrench and vise,he has never replied,yes emailed them.

 

[Uthink Uknow]

I never have a problem.
Paul has told me many misspell the carrier or whatever the internet company is called. I get him at

pbike4466@directv.com

Just copy and paste that eddress.

 

[pbike257]

I have sent "pike" numerous emails explaining I would like to buy wrench and vise,he has never replied,yes emailed them.

I have replied to you a number of times... You must have some form of blocker going on... causing you to not get my replies.


If you are serious about needing something unblock me and I will try again to email you... I am very busy right now building things for the hundreds of people that do get through.

Thank You,

Paul
pbike4466 @ directv.net also Pbike257 @ gmail.com

 

[tonedaddy]

I sent you an email a few minutes ago too.

 

[timeout]

I bought a wrench and vise from Paul. Works well and had no problems with the transaction. I used the email addres that he has posted. Like he says, his emails may be getting deposited directly into your junk mail. Type his email address into your contacts and that should not be a problem.

 

[butchlambert]

Paul is a great guy, but I cannot comment on your communication problem.

 

[SGT. Slaughter]

Who makes an Action wrench for a sako 491 rear entry will be desired.

 

[47WillysGuy]

I have replied to you a number of times... You must have some form of blocker going on... causing you to not get my replies.


If you are serious about needing something unblock me and I will try again to email you... I am very busy right now building things for the hundreds of people that do get through.

Thank You,

Paul
pbike4466 @ directv.net also Pbike257 @ gmail.com

I have email go straight to the “Junk” file.

 

[SmokinJoe]

pbike can make your Sako wrench, and they are great heat treated steel.

 

[SGT. Slaughter]

Thank you for responding, will he mind if you give his phone number?

 

[FNSafari]

The BAT action wrench is straight. If you have a Leonard stock, or possibly others with high comb, you can't get a hex wrench on it. I bought a PMA tool rear action wrench and handle, which has a bit of upward sweep to it to clear the stock. Nice.