• This Forum is for adults 18 years of age or over. By continuing to use this Forum you are confirming that you are 18 or older. No content shall be viewed by any person under 18 in California.

Rear bag rider for a orxy chassis

gman47564

Im a fan of the orxy chassis but the rear bag rider is lacking so i decided to remedy this problem with it.. i took a piece of 3/4 inch stainless steel round stock and milled one end of it to the middle of the shaft for a flat spot to match up with the buttom of the butt stock then drilled to holes through the bar to where my screws would be counter sunk in the bar. Then drilled and tapped the chassis.. problem solved and rides a bag nice now..20200215_122156.jpg
 
rick I had the local welding shop mill the bar down like that... all I had to do was drill the holes and tap the stock.... wasn't too hard really... and turned out nice and rides my rear bag great now..
 
You must log in or register to reply here.

Upgrades & Donations

This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.


Click Upgrade Membership Button ABOVE to get Gold or Silver Status.

You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.


To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.

Classified Ads

Forum statistics

Threads
165,859
Messages
2,204,935
Members
79,174
Latest member
kit10n

Share This Page

Back
Top