Reamer Question

[Mr.Spradlin]

I was given a set of 6PPC .263 ND Forgreens finish and resize reamers. They are marked .045 X 1 1/2. Does this mean anything to anyone?

Thanks
Matt

 

[Ggmac]

Neck / freebore and lead , the leade or ball seat is 1 Deg 30
I'm going from memory but I can check a few reamer prints .
Which was pretty standard for the 6 pPC .

Sorry I misread your numbers , the .045 is likely the freebore .

 

[Mr.Spradlin]

Neck /case end angle and lead , ball seat in degrees
End of chamber ( case neck ) is cut on a 45 deg the leade or ball seat is 1 min 30 sec.
I'm going from memory but I can check a few reamer prints .
Which was pretty standard for the 6 pPC .

Sir if you have a reamer print and you are willing to share it I would be most greatful.

Matt

 

[gunsandgunsmithing]

I was given a set of 6PPC .263 ND Forgreens finish and resize reamers. They are marked .045 X 1 1/2. Does this mean anything to anyone?

Thanks
Matt

.263 neck diameter
.045" free bore length
1.5 degree leade..which is also referred to as 1 degree30

 

[Mr.Spradlin]

.263 neck diameter
.045" free bore length
1.5 degree leade..which is also referred to as 1 degree30

Thank you sir!!!!
That is very helpful

Matt

 

[gunsandgunsmithing]

Thank you sir!!!!
That is very helpful

Matt

You're welcome Matt. I could be wrong but I'd bet a fair amount of money on it.

 

[Ggmac]

I have a reamer print , but not to tech savy . I can take a pic of it and email it . Pm me your email and I'll get it to you .
Gary

 

[Ggmac]

Print sent .